
FASTBACK 9 USER’S MANUAL, 203860 Rev. A 15
BINDING A DOCUMENT WITH
Lx-PERFECTBACK® LF STRIPS™
IX-B
1. If necessary, switch to PERFECTBACK LF mode (see
Section VII, page 16). If the machine is already in
PERFECTBACK LF mode, the display will read: “READY TO
BIND” … “PERFECTBACK LF.”
2. Select your Perfectback® strip according to your document
thickness:
10-125 sheets= Narrow Perfectback
125-250 sheets = Medium Perfectback
(This may vary slightly depending on the paper and cover
thickness.)
• HINT: If you are not sure which strip width to use, simply
place your document in the binding recess and push the
BIND button. The correct width will be shown on the
display.
3. Foldthestriptoa90°angle(gure20a).Makesurethe
adhesive side faces inward.
4. Place the strip into the binding recess with the adhesive
side facing up. The short side of the bent “L” should be
resting against the back wall. Slide the strip all the way to
theright(gure20b).
HINT: For a uniform strip width on your front cover—
regardless of document thickness—turn your document
in the binder with the front cover facing the back of the
machine.
5. Tamp your document cover and pages on the front at
surface of the housing so that they are straight. Place the
document on top of the strip and slide the document all the
waytotheright(gure21).
6. Tap the document on the top and the left to be sure all
pages are even. Push the pages backward to ensure proper
binding. Check that the document edge aligns with the edge
ofthestrip(gure22).
7. PresstheBINDbutton(gure23).Thebindingprocesswill
begin.
•
NOTE: Stopping the binding process: Duringtherst
several seconds of the binding cycle, you can push the
OPEN button (the orange button closest to the front) to
abort the whole process and open the document clamps.
Use a new binding strip when the process resumes.
8. Assoonasthedisplayashes“REMOVEBOOK,”pickup
the document and place it against a rear book support
fence(gure24).
9. Letthebounddocumentcoolforveminutes.
F I G U R E 20a
F I G U R E 20b
F I G U R E 21
F I G U R E 22
F I G U R E 23
F I G U R E 24
Comentários a estes Manuais